Williams Sound TGS SYS A Podręcznik Użytkownika Pobierz pdf (Strona 8)

Williams Sound

Helping People Hear

T16 TRANSMITTER FREQUENCY CHANGE PROCEDURE:

1. Remove the Transmitter from the Belt Clip Case.

2. Open the battery door and remove the battery.

3. Grasp the right corner of the battery door and lift the flap up and to your left. The back of the

Transmitter case will open like a book, exposing the circuit board.

4. Use the photo below to locate the channel selector switches.

5. Use the tip of a paper clip or a small screwdriver (not a pencil point) to move the switches to

correspond with the switch positions on the programming chart. Select a new frequency at

least two channels away from the one you are experiencing interference on. DO NOT TOUCH

ANY OF THE OTHER

ADJUSTMENTS!

6. Close the back of the Transmitter and install the battery. Plug the microphone in and turn the

Transmitter on to provide a tuning signal for the receivers. See the next section for receiver

tuning instructions.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Brak uwag

Williams Sound TGS SYS A Podręcznik Użytkownika Strona 8